0

Full Content is available to subscribers

Subscribe/Learn More  >

Geometric Modeling and Analysis for Gooseneck II: 2D Simplified Model for Quick Assessment

[+] Author Affiliations
Qiuye Tu, Rutan Deng, Dongdong Zhang, Xingjian Sun

Northwestern Polytechnical University, Xi’an, China

Paper No. GT2017-63282, pp. V02BT42A004; 10 pages
doi:10.1115/GT2017-63282
From:
  • ASME Turbo Expo 2017: Turbomachinery Technical Conference and Exposition
  • Volume 2B: Turbomachinery
  • Charlotte, North Carolina, USA, June 26–30, 2017
  • Conference Sponsors: International Gas Turbine Institute
  • ISBN: 978-0-7918-5079-4
  • Copyright © 2017 by ASME

abstract

In the previous studies, the proposed method for gooseneck geometric modeling employed two polynomials to construct the inner-wall and area distribution curves. The inflection point location served as the variable to control the inner-wall polynomial curve, and the peak point location and peak value to control the area distribution polynomial curve. In the effort to be quickly located, the control variables were provided with more geometric meaning. 3D numerical simulations indicated that there existed a total pressure recovery island for given solution area of the three control variables. Consequently, the relationships between the geometric parameters and the total pressure loss were set up.

This paper focused on the 2D simplifications to quickly address the control variables for the total pressure island. The studies were conducted in three aspects. First, the simplified model took the constructional blocking effects of struts into account. The baseline of the 2D simplified modeling was set at 30% spanwise near the hub through comparisons of different settings. Therefore, 70% blocking area compensated to outer-wall and 30% to inner-wall along the normal direction of the baseline. The 2D simulation results indicated that the static pressure distribution was consistent with the 3D results, but waves exited at the end walls of both leading and trailing edges due to the geometric changes. Second, the simplification considered the blocking effects of the wake. The wake was converted to boundary layer thickness, and moreover, compensation to the end wall was similar with the constructional blocking of struts. The simulation results revealed that wake blocking had very small impacts to the simplification, although the peak values of static pressure slightly increased at the end wall. Third, smoothing treatments were done for both inner-wall and outer-wall after the above compensating transformations. The results showed that smoothing treatments were very necessary and improved the waves located at end wall on the static pressure distribution which was nearly the same with 3D results. After all the simplifying treatments above, the final 2D results had almost the same total pressure loss distributions with the 3D results, and could save at least 40% calculation time as a quick assessment used to search the reasonable geometric solution areas of inflection point location and peak point location for minimum total pressure loss of the gooseneck.

Copyright © 2017 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In