0

Full Content is available to subscribers

Subscribe/Learn More  >

Materials Selection for Variable Geometry Turbine Nozzle for Gasoline Engine Application

[+] Author Affiliations
Vivek O. Shettigar, Apostolos Pesiridis

Brunel University, Uxbridge, Middlesex, UK

Paper No. GT2014-27119, pp. V01BT24A020; 11 pages
doi:10.1115/GT2014-27119
From:
  • ASME Turbo Expo 2014: Turbine Technical Conference and Exposition
  • Volume 1B: Marine; Microturbines, Turbochargers and Small Turbomachines; Steam Turbines
  • Düsseldorf, Germany, June 16–20, 2014
  • Conference Sponsors: International Gas Turbine Institute
  • ISBN: 978-0-7918-4558-5
  • Copyright © 2014 by ASME

abstract

Turbocharging is a key technology for reducing emissions in modern automotive internal combustion engines. The application of turbochargers has been regarded as the next step in the downsizing I.C. Engines. The technology has demonstrated its ability to increase the power of small engines by over 30%. This technology had a few drawbacks such as selection of appropriate air-fuel ratio which could either provide better transient response at low load condition or provide increased power at full load condition. In the quest to obtain the benefits of the both conditions, Variable Geometry Turbochargers (VGTs) were introduced. They account for a significant share of the market in mechanical turbocharging for diesel engines. The most common and efficient type of flow control device in use in VGT is the pivoting vane array located at the inlet of the turbocharger. The technology has been effectively applied over the past 20 years in diesel engines due to their relatively lower exhaust gas temperature (compared to gasoline engines) which has allowed inexpensive materials to be used. This isn’t the case for gasoline engines due to their high exhaust gas temperatures. In light of this technical challenge, the current paper discusses the attempts at application of VGTs in gasoline engines and evaluates further material options which can be considered as appropriate candidates for use in the movable nozzle section of a VGT. Exhaust gases temperatures of up to 1050°C with the working pressures reaching in excess of 2 bar is the working environment of a typical VGT. A CFD analysis of appropriately selected materials is presented in this paper and was applied to a generic pivoting vane mechanism, producing results for the stresses and deformations experienced by the selected materials. This paper also includes cost and manufacturability discussion of requirements which will eventually dictate the choice of any given material for mass production. The material is chosen with the help of an in-depth selection processes such as the Paul and Beitz method which includes weighing factors and performance indices. Performance indices can be considered as groups of material properties which represent few important aspect of the performance of the component.

Copyright © 2014 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In