0

Full Content is available to subscribers

Subscribe/Learn More  >

Realistic Trench Film Cooling With a Thermal Barrier Coating and Deposition

[+] Author Affiliations
David A. Kistenmacher, David G. Bogard

The University of Texas at Austin, Austin, TX

F. Todd Davidson

Graphene Materials, LLC, Austin, TX

Paper No. GT2013-95921, pp. V03BT13A057; 14 pages
doi:10.1115/GT2013-95921
From:
  • ASME Turbo Expo 2013: Turbine Technical Conference and Exposition
  • Volume 3B: Heat Transfer
  • San Antonio, Texas, USA, June 3–7, 2013
  • Conference Sponsors: International Gas Turbine Institute
  • ISBN: 978-0-7918-5515-7
  • Copyright © 2013 by ASME

abstract

Thermal barrier coatings (TBC’s) see extensive use in high temperature gas turbines. However, little work has been done to experimentally characterize the combination of TBC and film cooling. The purpose of this study is to investigate the cooling performance of a thermally conducting turbine vane with a realistic film cooling trench geometry embedded in TBC. Additionally, the effect of contaminant deposition on the realistic trench was studied. The trench is termed realistic because it takes into account probable manufacturing limitations. The vane model and TBC used for this study were designed to match the thermal behavior of an actual gas turbine vane with TBC by properly scaling their convective heat transfer coefficients, thermal conductivities, and characteristic length scales. This study built upon previously published results with various film cooling geometries consisting of round holes, craters, an ideal trench, and a novel trench. The previous study showed that large changes in blowing ratio resulted in negligible effects on cooling performance. Changes to film cooling geometry also resulted in minor effects on cooling performance. This study found that the realistic trench and an idealized trench perform similarly. However, the width of the realistic trench left the vane wall more exposed to mainstream temperatures, especially at lower film coolant flow rates. This study also found that the trench designs helped to mitigate deposition formation better than round holes; however, the realistic trench was more prone to deposition within the trench. The overall cooling effectiveness was similar for both trench designs and relatively unchanged from the pre-deposition performance while the overall cooling effectiveness for round holes increased due to the additional thermal insulation offered by the unmitigated deposition.

Copyright © 2013 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In