0

Full Content is available to subscribers

Subscribe/Learn More  >

Effect of Particle Size and Trench Configuration on Deposition From Fine Coal Flyash Near Film Cooling Holes

[+] Author Affiliations
Weiguo Ai, Robert G. Laycock, Devin S. Rappleye, Thomas H. Fletcher

Brigham Young University, Provo, UT

Jeffrey P. Bons

Ohio State University, Columbus, OH

Paper No. GT2009-59571, pp. 561-571; 11 pages
doi:10.1115/GT2009-59571
From:
  • ASME Turbo Expo 2009: Power for Land, Sea, and Air
  • Volume 3: Heat Transfer, Parts A and B
  • Orlando, Florida, USA, June 8–12, 2009
  • Conference Sponsors: International Gas Turbine Institute
  • ISBN: 978-0-7918-4884-5 | eISBN: 978-0-7918-3849-5
  • Copyright © 2009 by ASME

abstract

Particulate deposition experiments were performed in a turbine accelerated deposition facility to examine the effects of flyash particle size and trench configuration on deposits near film cooling holes. Deposition on two bare metal Inconel coupons was studied, with hole spacings (s/d) of 3.375 and 4.5. Two sizes of sub-bituminous coal ash particles were used, with mass mean diameter of 4 and 13 microns, respectively. The effect of a cooling trench at the exit of the cooling holes was also examined in this deposition facility. Experiments were performed at different angles of impaction. Particles were accelerated to a combustor exit flow Mach number of 0.25 and heated to 1183°C before impinging on a target coupon. The particle loading in the 1-hr tests was 160 ppmw. Blowing ratios were varied in these experiments from 0 to 4.0. Particle surface temperature maps were measured using two-color pyrometry based on RGB signals from a camera. Deposits generated from finer particles were observed to stick to the surface more tenaciously than larger particles. The capture efficiency measured for the small particles was lower than for the larger particles, especially at low blowing ratios. However, the finer particles exhibited a greater variation in deposition pattern as a function of hole spacing than seen with larger particles. The effect of trench configuration on deposition was examined by performing deposition tests with and without the trench for the same hole spacing and blowing ratio. The effects of trench configuration on capture efficiency, deposition pattern, and surface topography are reported. Deposition experiments at impingement angles from 45° to 15° showed changes in both deposit thickness and temperature. The trench increased cooling effectiveness, but did not change the particulate collection efficiency because the trench acted as a particulate collector.

Copyright © 2009 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In