0

Full Content is available to subscribers

Subscribe/Learn More  >

Designing Offshore Pipeline Systems Divided Into Sections of Different Design Pressures

[+] Author Affiliations
Gunnar Staurland, Morten Aamodt

Natural Gas, Statoil, Norway

Paper No. IPC2004-0217, pp. 1935-1943; 9 pages
doi:10.1115/IPC2004-0217
From:
  • 2004 International Pipeline Conference
  • 2004 International Pipeline Conference, Volumes 1, 2, and 3
  • Calgary, Alberta, Canada, October 4–8, 2004
  • Conference Sponsors: International Petroleum Technology Institute
  • ISBN: 0-7918-4176-6 | eISBN: 0-7918-3737-8
  • Copyright © 2004 by ASME

abstract

Norwegian waters have been a main arena for development of subsea pipeline technology over the last 25 year. The gas transportation systems from Norway to continental Europe comprise the largest and longest sub sea pipelines in the world. Codes traditionally require a pipeline to be designed with a uniform design pressure between stations with overpressure protection capabilities. However, the downstream part of a very long gas transmission pipeline may, after commissioning, rarely, if ever, see pressures near the pressure at the upstream end. There is, therefore, a potential for cost reduction and capacity improvement if two, or several, sections of different design pressure could be used without having to implement sub sea pressure regulation and overpressure protection facilities at the point of transition between the different sections of design pressure. In determining the lower design pressure the shutdown of the pipeline outlet facilities, at any point in time allowing for a practicable, achievable delay for closure of the upstream inlet valve has to be taken into account. The settle out pressure in a “normal” shut-in situation shall then not exceed the lower design pressure. In addition, deep water pipelines are often designed to withstand buckling due to bending and external pressure during installation, and may therefore locally tolerate a much higher internal pressure than the pipeline was designed for. Transmission pipelines crossing deepwater areas may therefore be designed for two or more operating pressures along the pipeline, thereby optimizing the cost. Even more important, for already existing pipelines, the capacity may be significantly increased by utilizing the upstream heavy wall sections. The operating pressure range for a long offshore gas transmission pipeline is very wide compared to an onshore line, typically between an upstream pressure of 150–250 bar, and a downstream pressure of 60 to 80 bar over a distance of several hundred kilometers. It may take hours to notice the closure of a downstream valve on the upstream pressure. Unless the pipeline is extensively packed, it is obvious that the pressure drop along the pipeline may be taken into account by allowing a lower design pressure for downstream part than for the upstream part. Thereby, the investment cost can be reduced. This paper describes the principles of designing a pipeline system divided into sections of different design pressures from a hydraulic point of view. The basis is the offshore standard for designing submarine pipeline systems, DNV OS-F101. The focusing will be on improvements in transportation efficiency, cost reductions and operational issues.

Copyright © 2004 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In