0

Full Content is available to subscribers

Subscribe/Learn More  >

Simulations to Determine Laminar Loss Coefficients for Flow in Circular Ducts With Arbitrary Planar Bifurcation Geometries

[+] Author Affiliations
Tim A. Handy, Evan C. Lemley

University of Central Oklahoma, Edmond, OK

Dimitrios V. Papavassiliou, Henry J. Neeman

University of Oklahoma, Norman, OK

Paper No. FEDSM2008-55181, pp. 921-928; 8 pages
doi:10.1115/FEDSM2008-55181
From:
  • ASME 2008 Fluids Engineering Division Summer Meeting collocated with the Heat Transfer, Energy Sustainability, and 3rd Energy Nanotechnology Conferences
  • Volume 1: Symposia, Parts A and B
  • Jacksonville, Florida, USA, August 10–14, 2008
  • Conference Sponsors: Fluids Engineering Division
  • ISBN: 978-0-7918-4840-1 | eISBN: 0-7918-3832-3
  • Copyright © 2008 by ASME

abstract

The goal of this study was to determine laminar stagnation pressure loss coefficients for circular ducts in which flow encounters a planar bifurcation. Flow conditions and pressure losses in these laminar bifurcations are of interest in microfluidic devices, in porous media, and in other networks of small ducts or pores. Until recently, bifurcation geometries had been studied almost exclusively for turbulent flow, which is often found in fluid supply and drain systems. Recently, pressure loss coefficients from simulations of a few arbitrary bifurcation geometries in two-dimensions have been published — the present study describes the extension of these two-dimensional simulations to three-dimensional circular ducts. The pressure loss coefficients determined in this study are intended to allow realistic simulation of existing laminar flow networks or the design of these networks. This study focused on a single inlet duct with two outlet ducts, which were allowed to vary in diameter, flow fraction, and angle — all relative to the inlet duct. All ducts considered in this study were circular with their axes in a common plane. Laminar stagnation pressure loss coefficients were determined by simulating incompressible flow through 475 different geometries and flow condition combinations. In all cases, the flow was laminar in the inlet and outlet ducts with a Reynolds number of 15 in the inlet duct. Simulations of the dividing flow geometries were done using FLUENT and a custom written computer code, which automated the process of creating the three-dimensional flow geometries. The outputs, pressure and velocity distributions at the inlet and outlets, were averaged over the circular ducts and then used to calculate pressure loss coefficients for each of the geometries and flow fraction scenarios simulated. The results for loss coefficient for the geometries considered ranged from 2.0 to 70. The loss coefficient for any geometry increased significantly as the outlet flow fraction increased. A consistent increase in loss coefficient was also observed as a function of decreasing outlet duct diameter. Less significant variation of the loss coefficient was observed as a function of the angles of the outlet ducts.

Copyright © 2008 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In