0

Full Content is available to subscribers

Subscribe/Learn More  >

An Augmented Multipoint Estimation Technique for Gas Path Analysis Model Generation

[+] Author Affiliations
Patrik Skölde, Markus Wallin, Tomas Grönstedt

Chalmers University of Technology, Göteborg, Sweden

Paper No. GT2004-53995, pp. 811-817; 7 pages
doi:10.1115/GT2004-53995
From:
  • ASME Turbo Expo 2004: Power for Land, Sea, and Air
  • Volume 2: Turbo Expo 2004
  • Vienna, Austria, June 14–17, 2004
  • Conference Sponsors: International Gas Turbine Institute
  • ISBN: 0-7918-4167-7 | eISBN: 0-7918-3739-4
  • Copyright © 2004 by ASME

abstract

A generic gas turbine simulation tool has been used for the development of a gas path analysis model for the PW100 engine. The suggested method estimates the performance parameters of an individual engine model based on overhaul test cell acceptance data of a well-serviced engine. The method makes simultaneous use of data from readings collected at three different power levels, by selecting a preliminary design model, which gives optimal off-design agreement with the recorded data. Measured thermodynamic data has been augmented with the use of low pressure and power turbine areas to maximise the use of available information. Nine performance parameters are estimated from, in total, 32 thermodynamic and geometric data recorded at the three different power levels. The resulting model is subsequently used for fault detection for the same engine. The method was tested on two data sets, representing a well serviced and a faulty condition. The known low-pressure turbine nozzle fault was successfully detected based on the output from the gas path analysis tool. The analysis was repeated for the three single power settings. Analysis based on all three operating points produced a marginal improvement in diagnostic capability, compared to the best single point case and substantially better than the worst single point case.

Copyright © 2004 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In