0

Full Content is available to subscribers

Subscribe/Learn More  >

Fluid Mechanics of Flow Through Rectangular Hydrophobic Microchannels

[+] Author Affiliations
Navid Kashaninejad, Weng Kong Chan, Nam-Trung Nguyen

Nanyang Technological University, Singapore

Paper No. ICNMM2011-58140, pp. 647-655; 9 pages
doi:10.1115/ICNMM2011-58140
From:
  • ASME 2011 9th International Conference on Nanochannels, Microchannels, and Minichannels
  • ASME 2011 9th International Conference on Nanochannels, Microchannels, and Minichannels, Volume 1
  • Edmonton, Alberta, Canada, June 19–22, 2011
  • Conference Sponsors: Heat Transfer Division
  • ISBN: 978-0-7918-4463-2
  • Copyright © 2011 by ASME

abstract

In this study, the effect of two important parameters have been evaluated for pressure driven liquid flows in microchannel in laminar regime by analytical modeling, followed by experimental measurement. These parameters are wettability conditions of microchannel surfaces and aspect ratio of rectangular microchannels. For small values of aspect ratio, the channel was considered to have a rectangular cross-section, instead of being two parallel plates. Novel expressions for these kinds of channels were derived using eigenfunction expansion method. The obtained two-dimensional solutions based on dual finite series were then extended to the case of a constant slip velocity at the bottom wall. In addition, for large values of aspect ratio, a general equation was obtained which is capable of accounting for different values of slip lengths for both upper and lower channel walls. Firstly, it was found out that for low aspect ratio microchannels, the results obtained by analytical rectangular 2-D model agree well with the experimental measurements as compared to one dimensional solution. For high aspect ratio microchannels, both models predict the same trend. This finding indicates that using the conventional 1-D solution may not be accurate for the channels where the width is of the same order as the height. Secondly, experimental results showed that up to 2.5% and 16% drag reduction can be achieved for 1000 and 250 micron channel height, respectively. It can be concluded that increasing the surface wettability can reduce the pressure drop in laminar regime and the effect is more pronounced by decreasing the channel height.

Copyright © 2011 by ASME

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In