0

Full Content is available to subscribers

Subscribe/Learn More  >

Heating Performance and Application Analysis of the Low-Pressure Injection Heater With Tapered Mixing Space

[+] Author Affiliations
Jing-yu Ran, Wei-di Wu, Zhi-hua Liu, Li Zhang

Chongqing University, Chongqing, China

Paper No. POWER2011-55049, pp. 361-366; 6 pages
doi:10.1115/POWER2011-55049
From:
  • ASME 2011 Power Conference collocated with JSME ICOPE 2011
  • ASME 2011 Power Conference, Volume 1
  • Denver, Colorado, USA, July 12–14, 2011
  • ISBN: 978-0-7918-4459-5
  • Copyright © 2011 by ASME

abstract

A new type of low-pressure injection heater was presented. The tapered structure of the heater’s mixture space was designed. Heating performance of the low-pressure heater was studied through the experimental method. Then, the influence of entrance parameters on the outlet temperature, the outlet pressure and the ejecting coefficient were analyzed. The results show that the increase of water mass flow rate can lead to the ejecting coefficient declines under the condition of steam pressure (0.2MPa). Meanwhile, the increases temperature at the outlet can be over 60°C at the inlet water temperature Tw = 20°C. The injection heater has a good adaptability for changing the entrance parameters, which can eliminate the danger that high pressure water enters system. At the same time, based on the theory of Equivalent Enthalpy Drop Method (EEDM) and thermodynamic system state equations, the results of calculation are also shown that the optimization transformation can improve a certain economic profit. The injection heater could be used in the low-pressure feed water system of 200MW steam power plant. The calculated results also indicate that it can replace the sub-last stage surface heat exchanger and raise thermal efficiency of the whole system by 0.07%. Moreover, if all low-pressure surface heat exchangers are replaced by the injection heater, the thermal economy of the whole system can be enhanced by 0.224%.

Copyright © 2011 by ASME
Topics: Pressure , Heating

Figures

Tables

Interactive Graphics

Video

Country-Specific Mortality and Growth Failure in Infancy and Yound Children and Association With Material Stature

Use interactive graphics and maps to view and sort country-specific infant and early dhildhood mortality and growth failure data and their association with maternal

NOTE:
Citing articles are presented as examples only. In non-demo SCM6 implementation, integration with CrossRef’s "Cited By" API will populate this tab (http://www.crossref.org/citedby.html).

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In